There are many kinds of faucet materials, stainless steel faucet is one of them. In daily home life, stainless steel faucet is unavoidable. However, stainless steel faucet needs different installation methods on different occasions. How to install stainless steel faucet?

Before installing the stainless steel faucet, be sure to remove the debris in the water supply pipe, and then connect the stainless steel faucet water inlet hose to prevent debris from blocking the faucet. A simple method can be to open the main gate valve of the water pipe in the home and let the water flow to perform a simple flush on the entire water pipe. Ensure that there are no impurities in the water pipe.

1. Thermostatic faucet:
Before installing the thermostatic faucet, please check if the water pipes are hot on the left and cold on the right. Remember not to connect the hot and cold water pipes wrongly to prevent the faucet from not working normally; the working water pressure of the faucet is 0.05-1.0MPa, and the applicable water temperature is 4℃- 90℃, so you must ensure that the household water pressure is within the required range during installation, otherwise the faucet will not be able to provide normal water supply.

2. Shower and bathtub faucet (wall hanging):
After you purchase a shower, bathtub, or wall-mounted stainless steel faucet, you can choose a suitable height to bury the water pipe. The distance between the hot and cold water pipes must reach 15 cm; the main body of the faucet has been adjusted to the best condition. Do not disassemble it by yourself during the installation process, otherwise the sealing performance of the faucet during use will be very poor.

Concealed shower faucet: After purchasing a concealed faucet, the valve core of the faucet is generally pre-buried in the wall. Be sure to pay attention to the thickness of the bathroom wall before embedding. If the wall is too thin, the spool will not be embedded. Do not remove the plastic protective cover of the valve core easily during pre-embedding, so as to avoid damage to the valve core by cement and other chores during pre-embedding.

3. Single hole basin:
When you find that there is a distance between the angle valve and the water pipe on the faucet, buy a special extension pipe to connect; during the installation process, be sure to connect the hot and cold water supply pipes according to the hot and cold water signs of the faucet. Be careful during the installation process, not to connect the two reversely. 35 work points from the basin down is the most suitable. During installation, a special angle valve must be selected, and the angle valve must be fixed to the hot and cold water pipes out of the wall.

4. Single hole kitchen:
The use frequency of kitchen faucet is high, and it is required to be stable, and the lock nut must be tightened.
After the faucet is installed, since other decorations in the home are still in progress, the state is just right to protect the faucet, because the faucet needs to be covered with a simple cover, mainly to avoid the adhesion of other construction cement slurry, welding slag, etc. Causes the faucet to become spotted or discolored or blocked and cannot be used.
www.faucetaccessory.com