1. First of all, everyone must prepare relevant special cleaning tools, such as fresh-keeping bags, soft brushes, etc. Secondly, you can use a soft brush to gently brush the faucet 4-5 times, and then pour a small amount of edible vinegar at home into the utensils, dip some vinegar with a soft brush, and gently brush out the stainless steel that must be removed. Position, and brush it at least 5 times. Then wrap the area where the vinegar has been brushed with a fresh-keeping bag, take it out after about 30 minutes, and gently scrub with a clean towel. At this time, you can find that the stainless steel faucet is getting brighter and brighter as a new mouth.
2. Or you can use paper towels instead of fresh-keeping bags, and then repeat the cleaning posture above, you can also achieve very good cleaning results. In addition, you can also squeeze the whitening toothpaste on the dirty area of the stainless steel faucet, and then use a wet and soft toothbrush dipped in the whitening toothpaste to clean it, then clean it with cold water and wipe it with a clean cloth. At this time, you can find that the faucet is repaired. It was as bright as before.
1. During the installation, everyone should prevent it from immediately colliding or bumping with the hard block, and it is not allowed to put strong chemical substances such as concrete and super glue on its surface to prevent damage to the gloss of the coating on the surface of the faucet. . If the stainless steel faucet is prepared in advance for a house under construction, it is likely that there will be grit residue in the water. We need to remove the dirt in the water pipe before installation, and add water until the water body turns blue to install the stainless steel faucet again.
2. Normally, when we use it, we should open it gently. It is not suitable for excessive force. You only need to gently shake the faucet to apply it along with its opening position. After application, everyone should scrub the surface of the stainless steel faucet neatly to prevent the surface from being rusted and endanger its smoothness. If the pressure of other faucets is normal, and the water output of a certain faucet is not smooth, then everyone needs to take out the dust cover at the faucet outlet and clean it. Generally, it can be repaired as before.