What is the installation method of the faucet? The faucet cannot be lacking in the restaurant kitchen. Everyone must wash the hands and disinfect the faucet, wash the dishes, and wash the dishes. After a long time, some faucets just started to fail, and a series of problems such as water seepage occurred. At this time, everyone must replace the faucet. So, how to install various faucets?

restaurant kitchen faucet
Installation process
1. Remove all the parts of the faucet (tooth tube, rubber pad, stainless steel plate washer, fixed nut);
2. Pass one of the water inlets through the opening position of the faucet and through the cabinet countertop;
3. Screw the passed water inlet into the seepage hole just below the faucet, and tighten it moderately;
4. Pass all the removed tooth pipes through the water inlet that has been screwed into the water inlet pipe of the faucet;
5. Pass the second water inlet through all the tooth pipes and screw it into the other water inlet pipe just below the faucet, and tighten it moderately;
6. Point the tooth tube to the bottom of the faucet and tighten it properly, adjust the part of the faucet, and then fix the spare parts and tighten them properly.
TIPS: The installation of restaurant kitchen faucets must be firm. Due to the high frequency of application of restaurant kitchen faucets and being moved around, it is very easy to loosen, so the lock nuts must be tightened.

Sanitary Ware Washbasin Faucet
Installation process
1. First of all, when you buy the faucet, you will find some basic parts below;
2. Then everyone put the copper buckle and a rubber pad into the two plastic hoses;
3. Then pass one end of the two pipes through the hole of the washbasin;
4. Then put the rubber pad into the plastic hose first, and then put the copper wire in;
5. Take the faucet again, twist the pipe's mouth and screw it on the faucet;
6. Then screw the copper wire on the faucet and put it into the hole of the basin to fix the faucet.
TIPS: When installing, be sure to install a special type of mixing valve, and the mixing valve must be fixed with the cold and hot water pipes that run out of water from the wall. The water inlet can be cut off if it is too long, but it does not need to be bent to 90%. degrees or more than ninety degrees. When installing the washbasin to drain, please don't forget to buy the small socket of the faucet.