1. It is not advisable to use a thermostatic faucet for fine solid lumps in drinking water;

2. If there is powdery sediment or soft plastic dirt in the drinking water, it is likely to reduce the sensitivity of the thermostatic valve core, and it is also likely to reduce the service life of the thermostatic faucet;

3. Reduce the distance between the electric water heater and the faucet as much as possible, so that the boiling water can reach the faucet as soon as possible;

4. The normal application pressure is 0.05Mpa ~ 0.5Mpa;

5. The hot and cold water supply pipes must not be installed backwards, the heating pipe must be on the left, and the cold water pipe must be on the right;

6. Be sure to clean up the installation site before installing the thermostatic faucet to prevent tiny lumps of material from damaging the rubber ring, external thread, thermostatic valve core and other parts of the faucet;

7. Please install it according to the markings in the instructions for use, and be careful not to miss, lose or damage all the gaskets or rubber rings;

8. The thermostatic faucet itself has no heating effect, please adjust the temperature of the electric water heater to 60℃~85℃;

9. The shower head and shower head pipe cannot bear the high temperature above 60℃;

10. After each application, please try to adjust the temperature adjustment knob on the left to below 40°C;

11. If the pressure of boiling water and cold water is too different, please use a screwdriver to adjust the gate valve of the support frame. This point must be paid attention to in the home where gas water heaters are used.