Basin faucet is a must-have product for kitchen and bathroom, and we cannot measure it by size. The emergence of stainless steel faucets has provided great convenience for the use of water in our lives, but when we use stainless steel faucets, we must also pay attention to saving water resources for our country. However, everything is a double-edged sword. While bringing convenience, there are also many failures. To a large extent, the failure of the faucet is not only determined by the quality of the faucet manufacturer, and its installation module also occupies a large position.

1. When installing the basin faucet, you should pay attention to the diameter of the water outlet. Now most of the water in the market belongs to the hard pipe, so you should pay attention to the height of the water outlet, which is 35 cm downward from the basin. When installing, a special angle valve must be selected, and the angle valve must be fixed with the hot and cold water pipes of the wall.

2. The installation of the single-hole kitchen faucet should be stable, because the kitchen faucet is used frequently, and it is easily moved around, so the lock nut must be tightened. Now there are some products on the market that fix the screw pipe with a larger nut. This kind of stabilization effect is very good. If the problem of water removal and pulling can be solved, it will be a popular trend in the future.

3. Before installing the thermostatic faucet, check whether the water pipe is hot on the left and cold on the right. Be sure not to connect the hot and cold water pipes wrongly, so as to avoid the faucet not working properly. Gas and solar water heaters cannot use thermostatic faucets because the water pressure is too low. When installing a thermostatic faucet, please don't forget to install a hot and cold water filter.

4. When it is found that there is a distance between the angle valve and the water pipe on the faucet, be sure to buy a special extension pipe to connect it. Never use other water pipes to connect it, because if the water pressure is large, it will easily fall off, leak water, and cause losses. . If the water inlet pipe is too long and exceeds the water outlet pipe, the part can be cut off according to the needs. If the angle is not suitable, it can be bent to the required position according to the needs. Do not bend hard to 90° or more. When installing the basin to drain, don't forget to buy the small interface of the faucet. Don't forget to flush the water pipes buried in the wall before installation.